Proper Maintenance Of Water Heater

You have to face the fact that your water heater is an essential appliance in your household. It never fails to provide enough warm water for your entire family until it breaks down. Having a malfunctioning water heater can be troublesome, especially if it’s not producing sufficient hot water for your household. When this happens, it is best to buy a replacement water heater for your convenience. If you want to extend the lifespan of your unit, maintain it regularly at least twice in a year.

You should remember to turn off your heating source, whether it is your circuit breaker or your gas supply valve. This will prevent you from encountering accidents during the process. Do not forget to turn off your cold water supply valve prior to maintaining your unit. This will prevent water from entering your tank.

Every water heater has a T&P valve installed inside the tank to protect it from overheating or unexpectedly blowing up. Allowing too much pressure sitting inside your tank can cause this valve to open more often, allowing water to leak easily. You can test it by allowing water to flow by lifting the lever and let it snap back on its own to stop the water flow. You should hear gurgling sounds during the process. If you think your T&P valve is malfunctioning, replace it as soon as possible.

Another tip on how to maintain your water heater is to drain and flush it a few times a year. This is an important step to remove the sediments and the hard water mineral minerals sitting inside your tank for a long time. However, you have to be careful not to scald yourself while draining your tank. You can avoid this incident from happening by switching off your heater the night before you perform a maintenance. Attach a standard hose to the drain valve and open it. Let the water flow to a gutter or drainage until your tank is empty. Use a bucket and put it below the drain valve to start flushing the filth inside your tank. Open your cold water supply valve and observe until the water is clear. You can enjoy clean water coming from your storage tank.

To avoid water heater leaks, lower your temperature down between 115 to 120 degrees F. It will not only protect your unit from overheating; doing this will help you cut back on your electric costs at the same time. You can easily find the temperature setting dial behind the heater panel if you have an electric water heater. For gas water heaters, turn the knob right on the gas valve.

Another important part of your water heater is the anode rod. This is responsible for absorbing all the hard water mineral deposits sitting inside your tank, preventing it from rusting completely. You may need to drain all the water to check the status of your anode rod. Once you see metal wires around the rod, replace it immediately.

If you haven’t tried insulating your water heater, it is probably a good idea to start late than never. There are a lot of insulation kits and heater blankets with an R-value of 24 or more. Consider buying a new insulation if you have an R-value lower than 24. Doing this helps sustain warm water inside your storage tank.

Remember to read guidelines in your unit’s manual before performing water heater maintenance. You can always call a specialist to help you with your unit, ensuring your heating system is in good hands. Performing water heater maintenance can take a lot of time, but worth your money in the end.

Looking to find the best service on water heater repairs , then visit www.waterheaterrepairrichmondca.com to learn more about professional water heater maintenance tips for you.

Videos Related to » Proper Maintenance Of Water Heater:

basic home maintenance how to drain a water - When draining a hot water heater attach a garden hose to the unit turn the vent line and lead ...

Google+